PWC
DIAGNOSTIC CABLE CONNECTION In order to establish communication, you must disconnect the instrument panel from the wiring and connect the diagnostic cable...
Tue, 8 Oct, 2019 at 1:44 PM
The error codes related to the "throttle valve position sensor" can be split into two groups, illustrated below along with the related check proc...
Tue, 8 Oct, 2019 at 2:03 PM
P0562 ERROR CODE The error appears if both the battery and the engine present the following conditions: • battery voltage below 6.5 V / rpm below 1280 • ...
Thu, 10 Oct, 2019 at 3:24 PM
Please note that in some engine series with E-TEC and Ficht Ram technologies, some components such as: injectors, fuel pump, ignition coils and oil pump may...
Thu, 10 Oct, 2019 at 3:30 PM
The vehicles of the makes SEA-DOO (BRP), SKI-DOO (BRP) and LYNX (BRP) have the peculiarity that, once a period of time above 30 seconds has elapsed with th...
Thu, 10 Oct, 2019 at 3:39 PM
IMPORTANT: Diagnostics cannot be run on the KAWASAKI MARINE immobilizer system. Adding a new key To configure a new key, proceed as follows: Pre-register...
Thu, 10 Oct, 2019 at 3:48 PM
In order to perform diagnostics on Kawasaki personal water craft you will need to be equipped with a special TEXA adapter cable. 3905015 Kawasaki PWC Diagn...
Mon, 14 Oct, 2019 at 10:13 AM
Please note that in Kawasaki PWC fault recording by the injection control unit cannot distinguish between an active and a memorized status; these two status...
Mon, 14 Oct, 2019 at 10:16 AM
During our tests we have found that sometimes the buzzer sounds even if there are no diagnostic errors. This is not a fault. This is the way the electronic...
Mon, 14 Oct, 2019 at 10:23 AM